Water Damage Repair Los Angeles Ca..

Los Angeles Water Damage Restoration

Water Damage Restoration – What Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be due to an overflow, flood or any other water damage and mold event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. The two main large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) as well as the RIA (Restoration Industry Association) that recommends standards for water damage and mold restoration. The S500 damage because of water guide is the benchmark tool that is used by companies that specialize in restoration of water damage.

Loss Assessment and Categorization – Loss evaluation is the first and the most crucial element of water damage and mold restoration. The assessment must be correct so that an appropriate response can be taken. In restorating the damage caused by water, technicians and also the insurance companies must work together and understand what is damaged and how to make restoring the harm. Identifying the source of the damage, documentation of damage, and accurate estimates are mandatory for any proper water damage restoration. Categorization relies on the contamination amounts of the water source. The categories are highlighted below

Category 1 – This is water from clean sources like pipes, sinks and toilets without faeces or urine.

Category 2 – This is water that has some contaminants like water coming from a dishwasher, washer or toilet with urine.

Category 3 – This can be water which is highly unsanitary and can do causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are some examples.

Decontamination and Drying – Right after the evaluation is finished, the whole process of drying and decontaminating begins on the site. Based on the extent of damage, damage caused due to water can be classified into 4 types. Class 1 Damage- When loss is restricted to your small area and much less water has been absorbed by materials. This results in slow evaporation rate. Class 2 Damage – When the damage would be to the whole room and carpet area. Class 3 Damage – Once the entire area is saturated with water and Class 4 Damage – when there are lots of deep saturation pockets. Decontamination and drying is really a key stage in Water damage and mold restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments must be used. Decontamination has to be done if contamination has been detected in the area. Decontamination may be done for the whole area or perhaps in specific pockets where contamination has been detected.

Monitoring and Completion – Monitoring the restoration process of damage caused due to damage is essential to achieve the desired results. One must be proactive throughout the monitoring process. Checking when the drying devices are setup properly, assessing if the personnel involved are qualified for the task and checking when the equipments are in working order inwtsy all part of the monitoring process. Necessary steps have to be taken if anything wrong is spotted during the monitoring process. The whole procedure of water damage and mold restoration will be classified as complete just once the humidity, temperature and the moisture content is really as per industry standards. Upon completing the water damage restoration process, the drying equipment can be removed.

Leave a comment

Your email address will not be published. Required fields are marked *

We are using cookies on our website

Please confirm, if you accept our tracking cookies. You can also decline the tracking, so you can continue to visit our website without any data sent to third party services.